-
Specifications Processor- Broadcom BCM2387 chipset. 1.2GHz Quad-Core ARM Cortex-A53 802.11 b/g/n Wireless LAN and Bluetooth 4.1 (Bluetooth Classic and LE) GPU -Dual Core VideoCore IV® Multimedia Co-Processor. Provides Open GL ES 2.0, hardware-accelerated OpenVG, and 1080p30 H.264 high-profile decode. Capable of 1Gpixel/s, 1.5Gtexel/s or 24GFLOPs with texture filtering and DMA infrastructure Memory- 1GB LPDDR2 Operating System- Boots from Micro SD card, running a version of the Linux operating system or Windows 10 IoT Dimensions- 85 x 56 x 17mm Power- Micro USB socket 5V1, 2.5A Connectors: *Ethernet- 10/100 BaseT Ethernet socket *Video Output- HDMI (rev 1.3 & 1.4 *Composite RCA (PAL and NTSC) *Audio Output -Audio Output 3.5mm jack, HDMI *USB- 4 x USB 2.0 Connector *GPIO Connector- 40-pin 2.54 mm (100 mil) expansion header: 2x20 strip *Providing 27 GPIO pins as well as 3.3 V, 5 V and GND supply lines *Camera Connector- 15-pin MIPI Camera Serial Interface (CSI-2) *Display Connector- Display Serial Interface (DSI) 15 way flat flex cable connector with two data lanes and a clock lane *Memory Card Slot- Push/pull Micro SDIO
-
RGB LED module consists of a plug-in full color LED made by R, G, B three pin PWM voltage input can be adjusted Section three primary colors (red / blue / green) strength in order to achieve full color mixing effect. Control of the module with the Arduino can be achieved Cool lighting effects.
Specifications
- the use of plug-in full-color LED
- RGB trichromatic limiting resistor to prevent burnout
- through the PWM adjusting three primary colors can be mixed to obtain different colors
- with a variety of single-chip interface
- the working voltage: 5V
- LED drive mode: common cathode driver
-
Based on TP4056, this includes two pieces of 3.7V lithium battery charger modules, one of which is Micro USB interface, the other is Mini USB interface. It is small size and light weight, especially for a single lithium battery charging. Features: - Input voltage: 4.5V ~ 5.5V - Input Interface: Micro USB port or Mini USB port - Charging method: linear charge - A full charge voltage: 4.2V - Charge Current: 1A (default), modify the onboard resistor to adjust the charging current according to the table below. - Charging accuracy: 1.5% - Charging indicator: Red LED charging, Blue LED full. - Output Reverse: lithium batteries can not be reversed.
-
- The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption; When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode.
- Jog type : the initial state is low , high touch , do not touch is low ( similar touch of a button feature )
- Module can be installed in such as surface plastic, glass of non-metallic materials
- In addition to the thin paper ( non-metallic ) covering the surface of the module , as long as the correct location of the touch , you can make hidden in the walls, desktops and other parts of buttonsFeatures:
- Low power consumption
- Power supply for 2 ~ 5.5V DC
- Can replace the traditional touch of a button
- Four M2 screws positioning holes for easy installation