-
NanoVNA-F V2 50kHz-3GHz IPS 4.3Inch LCD Display Vector Network Analyzer S-A-A-2 Antenna Analyzer Sho E-880 Measurement frequency: 50KHz -3GHz Display: 4.3inch, Resolution 800*480 Battery: 5000mAh Li-ion Battery RF output power: -9dBm (error within 1GHz: ±1dB) Frequency accuracy: <0.5ppm S21 dynamic range: 70dB (1.5GHz), 60dB (3GHz) S11 dynamic range: 50dB (1.5GHz), 40dB (3GHz) 2-port return loss: 20dB typ (1.5GHz), 13dB min (3GHz) Number of calibration points: 101 points Number of scanning points: 101 points Number of traces: 4 Number of mark points: 4 (the mark point bar can be moved up and down on the screen) Setting save: 5 groups (after saving, it can be directly recalled when it is used next time, no need to recalibrate, and the saved parameters before the last shutdown will be automatically recalled when it is turned on next time) Support calibration result interpolation, can measure without recalibration after adjusting the measurement frequency band Scan time: about 1.9s/1 time (50kHz ~ 3000MHz full frequency band)
-
CP2112 debug board USB to I2C Communication Module E-879 On-chip power-on reset circuit, on-chip voltage regulator: 3.45 V output Compliant with USB specification 2.0 standard; full speed (12Mbps) USB suspend status via SUSPEND and /SUSPEND pins Integrated 194-byte one-time programmable ROM for storing customizable product information 512-byte SMBus data buffer, configurable clock speed device address 7-bit value is the slave address of CP2112 Windows, Mac, and Linux HID to SMBus libraries API for rapid application development, open-access interface specifications. 8 GPIOs can be configured as input/output and open-drain/push-pull, configurable clock output for external devices 48MHz to 94kHz, switching LEDs during reading/write SMBus
-
Dynamo Hand Crank Charger E-874 Maximum Output Voltage: DC5.5V/Maximum Output Current: 600mA/Interface type: USB It is better than a solar charger because you can use it even without the heat of the sun It is great for emergency situations, for trekking, fishing, camping, mountain climbing, and even just for everyday use
-
MQ-136-Hydrogen Sulfide Gas Sensor Module E-869 Dual signal output (analog output and TTL level output) The TTL output effective signal is low. Analog output 0 ~ 5V voltage, the higher the concentration the higher the voltage. Good sensitivity to hydrogen sulfide, liquefied gas, natural gas, city gas, and smoke. with long service life and reliable stability fast response recovery characteristics
-
Supports multiple PIC18F/16F 40 Pin MCUs Supports PIC18F458, PIC18F45550, PIC16F877A Supports PIC Kit 3/3.5 Connector for Programming Connectors for 16 X 2 LCD and LM35/10K pot Analog Input. With UDB Headers for Studying Embedded Systems, Project Development & Embedded/IoT based Product Prototyping by attaching it to the UDB. 2 Keys for Digital Input and 1 LED attached with Output Pin. USB C connector for powering board 5V Phone Charger
-
RP2040 microcontroller with 2MB of flash memory On-board single-band 2.4GHz wireless interfaces (802.11n) Micro USB B port for power and data (and for reprogramming the flash) 40 pin 21mmx51mm ‘DIP’ style 1mm thick PCB Exposes 26 multi-function 3.3V general purpose I/O (GPIO) 23 GPIO are digital-only, with three also being ADC capable