The MAX6675 performs cold-junction compensation and digitizes the signal from a type-K thermocouple. The data is output in a 12-bit resolution, SPI™-compatible, read-only format. This converter resolves temperatures to 0.25°C, allows readings as high as 1024°C, and exhibits thermocouple accuracy of 8LSBs for temperatures ranging from 0°C to 700°C. The MAX6675 is available in a small, 8-pin SO package.

Water sensor brick is designed for water detection, which can be widely used in sensing rainfall, water level, and even liquid leakage. Water Detector / Sensor Connecting a water sensor to an Arduino is a great way to detect a leak, spill, flood, rain, etc. It can be used to detect the presence, the level, the volume and/or the absence of water. While this could be used to remind you to water your plants, there is a better Grove sensor for that. The sensor has an array of exposed traces, which read LOW when water is detected.

Tiny and lightweight with high output power. Servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds but smaller. You can use any servo code, hardware or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gear box, especially since it will fit in small places. It comes with a 3 horns (arms) and hardware. Specifications • Weight: 9 g • Dimension: 22.2 x 11.8 x 31 mm approx. • Stall torque: 1.8 kgf·cm • Operating speed: 0.1 s/60 degree • Operating voltage: 4.8 V (~5V) • Dead band width: 10 µs • Temperature range: 0 ºC – 55 ºC

This IR reflective sensor utilizes a TCRT5000 to detect color and distance. It emits IR and then detects if it receives the echo. This sensor is often used in line following robots, auto data logging on utility meters, because this module can sense if a surface is white or black. The measuring distance range from 1mm to 8mm, and the central point is about 2.5mm. There is also an on-board potentiometer to adjust the sensitivity. The infrared diode will emmitting the infrared continutelly when the module connect to the power, when the emitted infrared light has not been reflected or the strength is not big enough,the triode will in the off state, at this time, D0 output logic LOW and the signal indicate LED off. Application Idea Rainfall detecting Liquid leakage Tank overflow detector Features Supply Voltage: 3.3V~5V Detect distance: 1mm-8mm Digital Outputs HIGH when objects detected On-board indicator LED to show the results On-board potentiometer to adjust the sensitivity On-board LM393 chip

The detection range of this version is approximately 20 cm to 150 cm (8″ to 60″). The GP2Y0A02 uses a 3-pin JST PH connector that works with our 3-pin JST PH cables for Sharp distance sensors ; the top picture on the right shows a shorter-range Sharp analog distance sensor with one of these cables.