-
NodeMCU is an open source IoT platform. It includes firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which is based on the ESP-12 module. The term "NodeMCU" by default refers to the firmware rather than the development kits. The firmware uses the Lua scripting language. It is based on the eLua project, and built on the Espressif Non-OS SDK for ESP8266. It uses many open source projects, such as lua-cjson, and spiffs.
-
The nRF24L01 is used on a wide variety of applications that require wireless control. They are transceivers which this means that each module can transmit and receive data. These modules are very cheap and you can use them with any microcontroller (MCU). Specifications nRF24L01 – 2.4GHz RF Transceiver
- Low cost single-chip 2.4GHz GFSK RF transceiver IC
- Range with Antenna: 250Kb rate (Open area) >1000 meter
- Power: Ultra low power consumption
- Input Voltage: 3.3V
- Pins: 5V tolerant
-
The CC3D provides a crisp feel when flying tricopters, quads, hexas, octocopters, and even fixed wing planes.CC3D CopterControl Hardware Features-Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.-3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.-Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight performance.-Software support for Windows, Mac and Linux.-Direct high speed USB support with no drivers required, a truly plug and play device.-Spektrum satellite receiver support.-Futaba S-BUS hardware support.-Innovative Flexi-port technology for superior port flexibility.-4Mbits on-board EEPROM for configuration storage.