-
200grm Straight Bar Mini Load Cell RSN-157 Weight Capacity Max - 200 g Maximum Overload - 220 g Cell Repeatability Error Max - ± 50 mg Cell Non-Linearity Max - 50 mg Cell Hysteresis Max - 50 mg Electrical Properties Rated Output - 600 μV/V Rated Output Error Max ± 150 μV/V Output Impedance 1 kΩ Creep 100 mg/hr Temperature Effect on Zero 5 mg/°C Temperature Effect on Span 5 mg/°C Supply Voltage Min 3 V DC Supply Voltage Max 10 V DC Zero Balance Ratio ± 100 μV/V Material - Aluminium Alloy (LY12CZ) Screw Thread Size - 2.5M 47mm x 12mm x 6mm, 110mm Wire
-
The Winson WCS1600 current sensor provides economical and precise solution for both DC and AC current sensing in industrial, commercial and communications systems. The unique package provides easy implementation without breaking original system and makes current sensing possible. Typical applications include motor control, load detection and management, over-current fault detection and any intelligent power management system etc.
-
This constant Voltage current boost module has high efficiency and little heat, low ripple and Stable performance With digital display, can show input Voltage), output Voltage) and output current) Output with USB interface and identification resistor, a single Lithium battery can be boosted to 5V to charge your phone Has over current protection and short circuit protection(input 15A fuse), safe to use Application: DIY a stabilized power supply, charge your electronic devices, stabilize Voltage for solar panel and etc
-
W5500 Ethernet shield is designed using the WIZnet W5500 chip. It supports both 3.3V & 5V. This Ethernet Shield is compatible with Arduino and ARM embed Platform. Features -Suppport 3.3V / 5V. -High Speed Ethernet controller W5500 chip. -SPI interface. -Internal 32Kbytes Tx/Rx buffer. -10/100 Ethernet PHY embedded. -Support Auto Negotiation (Full / Half duplex, 10 / 100-based). -Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE. -User Selectable GPIO pin. -Support SD-card slot for storage. -Support I2C, UART interface.
-
CAN-BUS is a common industrial bus because of its long travel distance, medium communication speed and high reliability. It is commonly found on modern machine tools and as an automotive diagnostic bus. This CAN-BUS Shield adopts MCP2515 CAN Bus controller with SPI interface and MCP2551CAN transceiver to give your Arduino/Seeeduino CAN-BUS capability. With an OBD-IIconverter cable added on and the OBD-II library imported, you are ready to build an onboard diagnostic device or data logger.