-
Features
- Supports following Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
- Supports 8 independent sockets simultaneously
- Supports Power down mode
- Supports Wake on LAN over UDP
- Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3)
- Internal 32Kbytes Memory for Tx/Rx Buffers
- 10BaseT/100BaseTX Ethernet PHY embedded
- Support Auto Negotiation (Full and half duplex, 10 and 100-based)
- Not support IP Fragmentation
- 3.3V operation with 5V I/O signal tolerance
- LED outputs (Full/Half duplex, Link, Speed, Active)
Specifications
- Module size: 55mm x 28mm
- Power supply: 3.3v /5v
- SPI clock frequency(MAX): 80M
- Work current(typ): 128mA
-
The Sound Recorder Module uses the ISD1760 Chip to record and store voice signals. ISD1700 series recording chip is a kind of high integration, high performance chip. This module can be multiple recording, the sampling rate can be set to 6k or 8k by the on-board resistor. There are also some inside sounds to remind the user working state of the module, such as record beginning, record stopping, record erasing , etc. The recording data is stored in the FLASH, without any compression to ensure a good quality. You can easily control this module manually or by Arduino. There are some keys on the module including “REC”,”PLAY”,”EARSE”, you can control the module with these keys.
-
SIM800 is a complete Quad-band GSM/GPRS solution in a SMT type which can be embedded in the customer applications.SIM800 support Quad-band 850/900/1800/1900MHz, it can transmit Voice, SMS and data information with low power consumption. With tiny size of 24*24*3mm, it can fit into slim and compact demands of customer design. Featuring Bluetooth and Embedded AT, it allows total cost savings and fast time-to-market for customer applications.
-
Weight: 55g Dimension: 40.7×19.7×42.9mm Stall torque: 10kg/cm (4.8v); 12kg/cm (6v) Operating speed: 0.23sec/60degree (4.8v); 0.2sec/60degree (6.0v) Operating voltage: 4.8 ~ 6.6v Temperature range: 0- 55deg Gear Type: Metal gear Dead band width: 1us Power Supply: Through External Adapter servo wire length: 32cm Servo Plug: JR (Fits JR and Futaba) servo arms &screws included and fit with Futaba servo arm It’s universal “S” type connector that fits most receivers.
-
The TSL2561 is an inexpensive, yet sophisticated, light sensor. Unlike simpler sensors, like photoresistors and photodiodes, the TSL2561 incorporates both infrared and visible light sensors to better approximate the response of the human eye. Because the TSL2561 is an integrating sensor (it soaks up light for a predetermined amount of time), it is capable of measuring both very small and very large amounts of light.
-
6-channel relay module optocoupler protection with low trigger6 channels relay output module, relay output contacts maximum 250A 10A. Input IN1, IN2, IN3, IN4, IN5, IN6 signal line is active low. VCC, GND power input can be individually powered relay power input JD-VCC. Module size: 10.30cm * 5.27cmUses: 1, support all MCU control. 2, industrial areas; 3, PLC control; 4, smart home control;
-
Supports Full and Half-Duplex modes Automatic Programmable Retransmit on Collision Programmable Padding and CRC Generation Automatic Rejection of Erroneous Packets SPI Interface with Clock Speeds Up to 20 MHz The board 25MHZ crystal. The network interface board HR911105A. 5 V power supply pin. Stable performance. For Arduino SPI, AVR, PIC, LPC, STM32.