-
The CC3D provides a crisp feel when flying tricopters, quads, hexas, octocopters, and even fixed wing planes.CC3D CopterControl Hardware Features-Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.-3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.-Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight performance.-Software support for Windows, Mac and Linux.-Direct high speed USB support with no drivers required, a truly plug and play device.-Spektrum satellite receiver support.-Futaba S-BUS hardware support.-Innovative Flexi-port technology for superior port flexibility.-4Mbits on-board EEPROM for configuration storage.
-
The GP2Y0A41SK0F Sharp analog distance sensor features a detection range of 1.5″ to 12″ (4 cm to 30 cm). The shorter range gives you higher resolution measurements, and the lower minimum detection distance makes this sensor great for detecting very close objects. The distance is indicated by an analog voltage, making this sensor very easy to use.
-
Features:
- Dual channel stereo output 3 w 3 w power Class D
- Works with 2.5V-5v power supply
- High amplification efficiency 85%
- can directly drive 4 Ω/8 Ω small speakers
- Good sound quality & noise suppression
- Unique without LC filter class D digital power board
- Can use computer USB power supply directly
- Small Size, can easily fit in a variety of products
- Input audio should be via sheilded wire for best performance.
- Use proper filtered power supply with good filter capacitors.
- Take care not to short speaker wires else IC will get damaged.
- Make sure power supply never execeds 5.5V else IC will get damaged. Use regulated power supply.
-
The PCF8591 is a single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface. Three address pins A0, A1 and A2 are used for programming the hardware address, allowing the use of up to eight devices connected to the I2C-bus without additional hardware. Address, control and data to and from the device are transferred serially via the two-line bidirectional I2C-bus.
-
Supports multiple PIC18F/16F 40 Pin MCUs Supports PIC18F458, PIC18F45550, PIC16F877A Supports PIC Kit 3/3.5 Connector for Programming Connectors for 16 X 2 LCD and LM35/10K pot Analog Input. With UDB Headers for Studying Embedded Systems, Project Development & Embedded/IoT based Product Prototyping by attaching it to the UDB. 2 Keys for Digital Input and 1 LED attached with Output Pin. USB C connector for powering board 5V Phone Charger