-
The HDPMO1 is a dual-axis magnetic sensor, it is a complete sensing system with on-chip signal processing and integrated I2C bus, allowing the device to be connected directly to a microprocessor eliminating the need for A/D converters or timing resources. It can measure magnetic field with a full range of ±2 gausses and a sensitivity of 512counts/gauss @3.0 V at 25°C.
-
Bring oscillation source Audino 9012 drive Work Voltage:3.3V-5V Set bolt hole, easy to assemble PCB Dimension:3.3cm*1.3cm It and your Arduino will be able to play melodies. This is a small buzzer for the Sensor Shield. It creates different sound based on the different frequency of I/O toggling. Pin Definition : Vcc : 3.3V-5V GND : The Ground I/O : I/O Interface of SCM
-
Feature: Internal with logic level conversion circuit. No need external 5V level to turn into a 3.3V level The power input port with anti-anti-circuit. To avoid accidental power plug reversed, leading to the module burned HM-10, HM-11 series Bluetooth module using TI CC2540 chip, configuration 256Kb space, support AT commands, you can change the role (master and slave mode) and the baud rate, the device name, Pairing password and other parameters, convenient and flexible.
-
Features: -With relay output, this module is used to detect the humidity and control related the device power directly. -This product make use of HR202 humidity sensor. -The comparator outputs drive relays directly. It connects to 220V AC or other devices. -With leads, sensor interface can be installed with pin. -It's easy to install with 4 0.3cm fixing bolt hole. -When ambient humidity exceeds the setting threshold value the relay sucks and shuts, what's more, the common terminal connects to the start. -If the ambient humidity below the setting threshold value, the situation will be counter. -Common, normally open and normally closed the three ports are equivalent to a dual-control switch. -When the relay coil is electrified, the common will connect to the normally open, otherwise, the common will connect to normally closed.
-
Product Description: The MPU6050 devices combine a 3-axis gyroscope and a 3-axis accelerometer on the same silicon together with an onboard Digital Motion Processor (DMP) capable of processing complex 9-axis MotionFusion algorithms. The parts’ integrated 9-axis MotionFusion algorithms access external magnetometers or other sensors through an auxiliary master I2C bus, allowing the devices to gather a full set of sensor data without intervention from the system processor. The devices are offered in the same 4x4x0.9 mm QFN footprint and pinout as the current MPU-3000? family of integrated 3-axis gyroscopes, providing a simple upgrade path and making it easy to fit on space constrained boards. The InvenSense Motion Apps Platform that comes with the MPU-6050 abstracts motion-based complexities, offloads sensor management from the operating system and provides a structured set of APIs for application development. For precision tracking of both fast and slow motions, the parts feature a user-programmable gyro full-scale range of ±250, ±500, ±1000, and ±2000°/sec (dps) and a user-programmable accelerometer full-scale range of ±2g, ±4g, ±8g, and ±16g.
-
HX711 is a precision 24-bit analog to-digital converter (ADC) designed for weigh scales and industrial control applications to interface directly with a bridge sensor. The input multiplexer selects either Channel A or B differential input to the low-noise programmable gain amplifier (PGA). Channel A can be programmed with a gain of 128 or 64, corresponding to a full-scale differential input voltage of ±20mV or ±40mV respectively, when a 5V supply is connected to AVDD analog power supply pin. Channel B has a fixed gain of 32.