-
It is an easily cascadable 8×8 monochromatic LED dot matrix display module with onboard MAXIM’s MAX7219 LED driver chip. The MAX7219 allows you to drive the LED matrix using only three I/O pins of Arduino or any other microcontroller. The LED matrix module used in Easy Matrix has a bigger dot size (5mm) and has the overall display dimensions of 60.2mm x 60.2mm (2.4″x2.4″). It is easily cascadable in series with the help of precisely aligned male and female header pairs located on the left and right sides of the display module. With lots of freely available Arduino libraries for MAX7219 chip, this module is easy to use in any Arduino project for displaying basic text and animation.
-
The MAX6675 performs cold-junction compensation and digitizes the signal from a type-K thermocouple. The data is output in a 12-bit resolution, SPI™-compatible, read-only format. This converter resolves temperatures to 0.25°C, allows readings as high as 1024°C, and exhibits thermocouple accuracy of 8LSBs for temperatures ranging from 0°C to 700°C. The MAX6675 is available in a small, 8-pin SO package.
-
Feature: *Operating voltage: 5V. *On-board MAX485 chip. *A low power consumption for the RS-485 communication. *Slew-rate limited transceiver. *5.08mm pitch 2P terminal. *Convenient RS-485 communication wiring. *All pins of chip have been lead to can be controlled through the microcontroller. *Board size: 44 x 14mm.
-
Dry reed pipe needs and magnet is used together, in the induction to have certain magnetic, a conducting state, module output low level, no magnetic, is off state, output high level, dry reed pipe and magnetic induction distance within in 1.5 cm beyond insensitive or will not trigger phenomenon. Module DO output end of the single chip microcomputer can I/O port directly connected, through the single chip microcomputer can detect dry reed pipe state trigger. Module DO output end and relay IN end connected to form high power dry reed pipe switch, direct control high voltage.
-
'-The lamp brightness can be adjusted by requirement,it is very to operate. -It can touch in medium protection,such glass,acrylic,plastic,ceramics and so on,which is very safe. -Wide application of voltage range,you can choose arbitrarily between 2.4V to 4.5V. -Anti power and phone interference,the EFT can reach above /-2KV;the touch response sensitivity and reliability will not affected by the close distance or multi-angle mobile phone interference. -Install: Needn’t to touch copper foil directly,the dimming can be processed across acrylic glass(above 3mm) or plastic. -Application:It can control LED module,light and so on.It is available for indoor LED,lighting lamp,DIY automotive lights dimming refit. -Function:Single touch,using the principle of capacitance touch .-The default function is switch,dimming,with brightness memories LED touch dimming.It will light slowly when turn on the lights,and become dark slowly when turn off,which effectively avoid the stimulation to eyes. -Dimming mode:Non-polar PWM dimming. -Wiring method:PCB board(VCC,GND) is power input,(LED , LED-) is connected with the LED lamps of positive and negative level (fingerprint) touch area, also can wire to lead out (the wiring should not be too long), copper skin area should be 2x3cm. With copper foil copper foil board module will side to the shell side.