-
- Product Name : DC Solenoid Electromagnet;Model : 0520S-24B70;Rated Voltage : DC 24V
- Current : 0.34A;Power : 8.22W;Type : Pull
- Start Force & Stroke : 5mm 0.003Kg;End Force & Stroke : 0mm 0.1Kg;Total Size : 3.5 x 1.5 x 1.2cm/1.4" x 0.59" x 0.47"(L*W*T)
- Shaft Diameter : 5mm/0.2";Cable Length : 13cm /5.1";Material : Metal, Electronic Parts
- Weight : 20g;Package Content : 1 x DC Solenoid Electromagnet
-
SIM800C is a complete Quad-band GSM/GPRS solution in a SMT type, which can be embedded in the customer applications. SIM800C supports Quad-band 850/900/1800/1900MHz, it can transmit Voice, SMS and data information with low power consumption. With tiny size of 17.6*15.7*2.3mm, it can smoothly fit into slim and compact demands of customer design. -
The GP2Y0A710K infrared sensor is a new version of GP2Y0A700K which takes a continuous distance reading and reports the distance as an analog voltage with a distance range of 1m (39.3") to 5.5m (216.5"). The interface is 5-wire JST connector (included with pins) with dual Vcc, dual Gnd, and a single output voltage. Power, ground and signal wiring is enough to read a continuous analog voltage representing distance. A software lookup table can be implemented to translate the voltages to distances. -
The detection range of this version is approximately 20 cm to 150 cm (8″ to 60″). The GP2Y0A02 uses a 3-pin JST PH connector that works with our 3-pin JST PH cables for Sharp distance sensors ; the top picture on the right shows a shorter-range Sharp analog distance sensor with one of these cables. -
The PD153 is designed as one kind of TO-18 type color sensor that can be used in (1)read out of paper currency's color in money exchanger and (2)read out of color temperature and wave-length and (3)detection of object's color applications. -
This is a simple-to-use Carbon Monoxide (CO) sensor, suitable for sensing CO concentrations in the air. The MQ-7 can detect CO-gas concentrations anywhere from 20 to 2000ppm. Features High sensitivity to CH4，Natural gas Small sensitivity to alcohol, smoke Fast response Stable and long life Simple drive circuit -
The 28-BYJ48 comes with Breakout using ULN2003 As a Motor driver chip . Rated voltage ： 5VDC Number of Phase 4 Speed Variation Ratio 1/64 Stride Angle 5.625° /64 Frequency 100Hz DC resistance 50Ω±7%(25℃) Idle In-traction Frequency > 600Hz Idle Out-traction Frequency > 1000Hz In-traction Torque >34.3mN.m(120Hz) Self-positioning Torque >34.3mN.m Friction torque 600-1200 gf.cm Pull in torque 300 gf.cm Insulation grade A -
This sensor sits in line with your water line and contains a pinwheel sensor to measure how much liquid has moved through it. There's an integrated magnetic hall effect sensor that outputs an electrical pulse with every revolution. The hall effect sensor is sealed from the water pipe and allows the sensor to stay safe and dry. The sensor comes with three wires: red (5-24VDC power), black (ground) and yellow (Hall effect pulse output). By counting the pulses from the output of the sensor, you can easily calculate water flow. Each pulse is approximately 2.25 milliliters. Note this isn't a precision sensor, and the pulse rate does vary a bit depending on the flow rate, fluid pressure and sensor orientation. It will need careful calibration if better than 10% precision is required. However, its great for basic measurement tasks! -
Specifications • Weight: 55 g • Dimension: 40.7 x 19.7 x 42.9 mm approx. • Stall torque: 9.4 kgf·cm (4.8 V ), 11 kgf·cm (6 V) • Operating speed: 0.17 s/60º (4.8 V), 0.14 s/60º (6 V) • Operating voltage: 4.8 V a 7.2 V • Running Current 500 mA – • Stall Current 2.5 A (6V) • Dead band width: 5 µs • Stable and shock proof double ball bearing design • Temperature range: 0 ºC – 4.8 V a 7.2 V – 900 mA (6V) double ball bearing design 55 ºC -
Weight: 55g Dimension: 40.7×19.7×42.9mm Stall torque: 10kg/cm (4.8v); 12kg/cm (6v) Operating speed: 0.23sec/60degree (4.8v); 0.2sec/60degree (6.0v) Operating voltage: 4.8 ~ 6.6v Temperature range: 0- 55deg Gear Type: Metal gear Dead band width: 1us Power Supply: Through External Adapter servo wire length: 32cm Servo Plug: JR (Fits JR and Futaba) servo arms &screws included and fit with Futaba servo arm It’s universal “S” type connector that fits most receivers.
YOUR PARTNER IN TECHNOLOGY SOLUTIONS
YOUR PARTNER IN TECHNOLOGY SOLUTIONS
No.1030, Shriram Building,
Near Nagnath Par,
Sadashiv Peth, Pune – 411030,
Maharashtra, India
Visit Our store
STORE TIMINGS
Monday to Saturday
10:00 AM to 7.30 PM
(Store closed on all Sundays and Public Holidays)
NOTE
*All the prices are excluding Tax rates & are subject to change after a specific period of time.
Copyright © 2024@AbhinavDCS
