'-U-BLOX NEO-6M module with high-gain active antenna; -TTL level, compatible with 3V/5V systems; -Baud rate: 9600kbps (default), adjustable by u-center; -Provided IPX interface for different active antennas; -Provided rechargeable battery backup, enabling to save ephemeris data on power down; -Support hot start.

'-The lamp brightness can be adjusted by requirement,it is very to operate. -It can touch in medium protection,such glass,acrylic,plastic,ceramics and so on,which is very safe. -Wide application of voltage range,you can choose arbitrarily between 2.4V to 4.5V. -Anti power and phone interference,the EFT can reach above /-2KV;the touch response sensitivity and reliability will not affected by the close distance or multi-angle mobile phone interference. -Install: Needn’t to touch copper foil directly,the dimming can be processed across acrylic glass(above 3mm) or plastic. -Application:It can control LED module,light and so on.It is available for indoor LED,lighting lamp,DIY automotive lights dimming refit. -Function:Single touch,using the principle of capacitance touch .-The default function is switch,dimming,with brightness memories LED touch dimming.It will light slowly when turn on the lights,and become dark slowly when turn off,which effectively avoid the stimulation to eyes. -Dimming mode:Non-polar PWM dimming. -Wiring method:PCB board(VCC,GND) is power input,(LED , LED-) is connected with the LED lamps of positive and negative level (fingerprint) touch area, also can wire to lead out (the wiring should not be too long), copper skin area should be 2x3cm. With copper foil copper foil board module will side to the shell side.

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chip-sets.

The MB102 is a breadboard power supply module manufactured by the YuRobot . This module has the marking 545043 and MB V2 on the printed circuit board (PCB). It provides dual 5 V and 3.3 V power rails, and has a multi-purpose female USB socket.