-
3S 25A 18650 Lithium Ion BMS for 11.1V Battery E-953 Charging Voltage - 12.6V DC CC/CV Balance Voltage for Single Cell - 4.2V Max Continuous Charge/Discharge Current - 25A Overcharge Detection Voltage - 4.25V Overcharge Release Voltage - 4.15V Over-Discharge Detection Voltage - 2.3V Over-Discharge Release Voltage - 3.0V Over-Current Detection Current - 35A -
PD/QC/AFC Fast Charge Decoy Trigger E-965 Supports Multiple Protocols Protocol Selection Voltage and Current Adjustment Compact Design Safety Features -
6800uF 63V 105 Degree Electrolytic Capacitor 24x44mm C105-87 Tolerance – -±20% Voltage Rated— 63 V Mounting Type -Radial, Through Hole Maximum Operating Temperature -105°C Lead Spacing – 10 mm Size / Dimension – 24.00mm / Height – Seated (Max)-44.00mm -
3.7V 2200mah Rechargeable 1 Cell Lithium Battery Pack HONGLI – With BMS BT-82 This battery pack can be used to power DIY projects This 1S Lithium Battery Pack is made up of 2200mAh 18650 cell -
1759156 - 16 PIN RA MALE OPEN# Image shown is a representation only #
-
Nominal voltage - 12 V. Switching current max - 1A AC 2A DC Working temperature - 45 degree C. To 55 degree C# Image shown is a representation only #
-
This is a breakout board for the fully integrated Hall Effect based linear ACS712 current sensor. The sensor gives precise current measurement for both AC and DC signals. Thick copper conductor and signal traces allows for survival of the device up to 5 times overcurrent conditions. The ACS712 outputs an analog voltage output signal that varies linearly with sensed current. The device requires 5VDC for VCC and a couple of filter capacitors. Please keep in mind that though the ACS712 is rated for 2.1kV isolation, the PCB it is on is not designed for that type of voltage. Please keep that in mind if you are using this breakout in high voltage applications. -
This is a simple-to-use Carbon Monoxide (CO) sensor, suitable for sensing CO concentrations in the air. The MQ-7 can detect CO-gas concentrations anywhere from 20 to 2000ppm. This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
YOUR PARTNER IN TECHNOLOGY SOLUTIONS
YOUR PARTNER IN TECHNOLOGY SOLUTIONS
No.1030, Shriram Building,
Near Nagnath Par,
Sadashiv Peth, Pune – 411030,
Maharashtra, India
Visit Our store
STORE TIMINGS
Monday to Saturday
10:00 AM to 7.30 PM
(Store closed on all Sundays and Public Holidays)
NOTE
*All the prices are excluding Tax rates & are subject to change after a specific period of time.
Copyright © 2024@AbhinavDCS
