-
- Product Name : DC Solenoid Electromagnet;Model : 0520S-24B70;Rated Voltage : DC 24V
- Current : 0.34A;Power : 8.22W;Type : Pull
- Start Force & Stroke : 5mm 0.003Kg;End Force & Stroke : 0mm 0.1Kg;Total Size : 3.5 x 1.5 x 1.2cm/1.4" x 0.59" x 0.47"(L*W*T)
- Shaft Diameter : 5mm/0.2";Cable Length : 13cm /5.1";Material : Metal, Electronic Parts
- Weight : 20g;Package Content : 1 x DC Solenoid Electromagnet
-
SIM800C is a complete Quad-band GSM/GPRS solution in a SMT type, which can be embedded in the customer applications. SIM800C supports Quad-band 850/900/1800/1900MHz, it can transmit Voice, SMS and data information with low power consumption. With tiny size of 17.6*15.7*2.3mm, it can smoothly fit into slim and compact demands of customer design.
-
The GP2Y0A710K infrared sensor is a new version of GP2Y0A700K which takes a continuous distance reading and reports the distance as an analog voltage with a distance range of 1m (39.3") to 5.5m (216.5"). The interface is 5-wire JST connector (included with pins) with dual Vcc, dual Gnd, and a single output voltage. Power, ground and signal wiring is enough to read a continuous analog voltage representing distance. A software lookup table can be implemented to translate the voltages to distances.
-
40KHz Ultrasonic Transducer Transmitter and Receiver Pair. These transducers are very useful in making various sensors for detecting obstacles and measuring distances. Features Use for motion or distance sensing Frequency: 40kHz ±1.0kHz Aluminum case Capacitance: 2000pF ±20% Transmitter: bandwidth 5.0kHz/100dB, sound pressure level 112dB/40 ±1.0kHz Receiver: bandwidth 5.0kHz @ -75dB, min. sensitivity 67dB/40 ±1.0kHz (0dB vs. 1V µbar) R=3.9k. Lead length/spacing: 0.28" Case size: 0.30"H x 0.43" Dia.
-
This is a simple-to-use Carbon Monoxide (CO) sensor, suitable for sensing CO concentrations in the air. The MQ-7 can detect CO-gas concentrations anywhere from 20 to 2000ppm. Features High sensitivity to CH4,Natural gas Small sensitivity to alcohol, smoke Fast response Stable and long life Simple drive circuit
-
The 28-BYJ48 comes with Breakout using ULN2003 As a Motor driver chip . Rated voltage : 5VDC Number of Phase 4 Speed Variation Ratio 1/64 Stride Angle 5.625° /64 Frequency 100Hz DC resistance 50Ω±7%(25℃) Idle In-traction Frequency > 600Hz Idle Out-traction Frequency > 1000Hz In-traction Torque >34.3mN.m(120Hz) Self-positioning Torque >34.3mN.m Friction torque 600-1200 gf.cm Pull in torque 300 gf.cm Insulation grade A
-
This sensor sits in line with your water line and contains a pinwheel sensor to measure how much liquid has moved through it. There's an integrated magnetic hall effect sensor that outputs an electrical pulse with every revolution. The hall effect sensor is sealed from the water pipe and allows the sensor to stay safe and dry. The sensor comes with three wires: red (5-24VDC power), black (ground) and yellow (Hall effect pulse output). By counting the pulses from the output of the sensor, you can easily calculate water flow. Each pulse is approximately 2.25 milliliters. Note this isn't a precision sensor, and the pulse rate does vary a bit depending on the flow rate, fluid pressure and sensor orientation. It will need careful calibration if better than 10% precision is required. However, its great for basic measurement tasks!