Based on TP4056, this includes two pieces of 3.7V lithium battery charger modules, one of which is Micro USB interface, the other is Mini USB interface. It is small size and light weight, especially for a single lithium battery charging. Features: - Input voltage: 4.5V ~ 5.5V - Input Interface: Micro USB port or Mini USB port - Charging method: linear charge - A full charge voltage: 4.2V - Charge Current: 1A (default), modify the onboard resistor to adjust the charging current according to the table below. - Charging accuracy: 1.5% - Charging indicator: Red LED charging, Blue LED full. - Output Reverse: lithium batteries can not be reversed.

• The module is based on a touch-sensing IC  (TTP223B) capacitive touch switch module. In the normal state, the module output  low, low power consumption; When a finger touches the corresponding position,  the module output high, if not touched for 12 seconds, switch to low-power mode.
• Jog type : the initial state is low , high  touch , do not touch is low ( similar touch of a button feature )
• Module can be installed in such as surface  plastic, glass of non-metallic materials
• In addition to the thin paper ( non-metallic )  covering the surface of the module , as long as the correct location of the  touch , you can make hidden in the walls, desktops and other parts of buttonsFeatures:
• Low power consumption
• Power supply for 2 ~ 5.5V DC
• Can replace the traditional touch of a button
• Four M2 screws positioning holes for easy  installation

The BMP280 sensor is an environmental sensor with temperature, barometric pressure that is the next generation upgrade to the BMP085/BMP180/BMP183. This sensor is great for all sorts of weather sensing and can even be used in both I2C and SPI. Features: - Pressure range: 300 ~ 1100hPa (altitude 9000 m ~ -500 m); - Working voltage: 1.71 - 3.6VDC; - Low power consumption: 4μA; - High precision: at low-power mode, the resolution is 0.06hPa (0.5 meters); - Temperature output; - Communication interface: I2C or SPI; typical application: - GPS precise navigation (dead reckoning, the upper and lower bridge detection, etc.); - indoor and outdoor navigation; - The weather forecast; - The vertical velocity indication (rise / sink speed);

Capacitor type - Ceramic Quantity: 100 (5 each per value)

# Image shown is a representation only # 

The Soil Moisture Sensor is a simple breakout for measuring the moisture in soil and similar materials. The soil moisture sensor is pretty straight forward to use. The two large exposed pads function as probes for the sensor, together acting as a variable resistor. The more water that is in the soil means the better the conductivity between the pads will be and will result in a lower resistance, and a higher SIG out.

This bi-directional logic level converter is a small device that safely steps down 5V signals to 3.3V AND steps up 3.3V to 5V at the same time. This level converter also works with 2.8V and 1.8V devices. What really separates this Logic level converter from our previous versions is that you can successfully set your high and low voltages and step up and down between them safely on the same channel. Each level converter has the capability of converting 4 pins on the high side to 4 pins on the low side with two inputs and two outputs provided for each side.

Bring oscillation source Audino 9012 drive Work Voltage:3.3V-5V Set bolt hole, easy to assemble PCB Dimension:3.3cm*1.3cm It and your Arduino will be able to play melodies. This is a small buzzer for the Sensor Shield. It creates different sound based on the different frequency of I/O toggling. Pin Definition : Vcc : 3.3V-5V GND : The Ground I/O : I/O Interface of SCM